Tormek TT50 Diamond Stone Truing Tool

1. Easy feeding across the stone. You can conveniently and without pressing with your thumbs feed the diamond cutter across the stone. You achieve an even feeding by alternately turning the two knobs with both your hands. The feed can be made in both directions.
Thanks to the controlled feed, you get an even and flat stone surface with no ridges. There is no need to flatten afterwards with the Stone Grader SP?650. The slower you feed, the finer the surface you will achieve. A traverse time of 90 seconds across the stone gives you a good finish with hardly any visible grooves.
2. Controlled cutting depth. The cutting depth is set exactly by the Micro Adjust on the Universal Support. New Universal Supports will have a scale with increments for each 0,25 mm or 0,01"". You can also use your existing Micro Adjust, which has no scale. A cutting depth of 0,25 mm or 0,01"" corresponds to a sixth of a full turn.
3. Increased steel removal. With a higher feed speed across the stone (approximately 30 seconds instead of 90 seconds) the surface will have pronounced grooves, which will cause the stone to grind faster. This is beneficial, when sharpening or shaping tools in hard steel with a large bevel area, e.g. turning skew chisels and electric planer/jointer blades.